Easy Setup 7-7The Easy Setup Profile screen appears.Easy Setup ProfileThe Easy Setup Profile screen is where you configure the parameters that control the Netopia R7100’sconnection to a specific remote destination, usually your ISP or a corporate site.On a Netopia R7100 SDSL Router you can add up to 15 more connection profiles, for a total of 16, althoughyou can only use one at a time.1. To enable address translation, toggle Address Translation Enabled to Yes (the default). For moreinformation on Network Address Translation, see Chapter 9, “IP Setup and Network Address Translation,”on page 9-1.2. You can toggle IP Addressing to either Numbered or Unnumbered.Numbered is the default for SDSL. It assigns a unique IP address to the SDSL WAN interface, as requiredby most ISPs’ routers. Unnumbered may be used for simpler configurations such as point-to-point shorthaul applications.3. Select the Local WAN IP Address field. The default address is 0.0.0.0, which allows for dynamicaddressing, when your ISP assigns an address each time you connect. However, you may enter anotherspecific address if you want to use static addressing. In that case, enter the local WAN address your ISPgave you.When using numbered interfaces, the Netopia Router will use its local WAN IP address and subnet mask tosend packets to the remote router. Both routers have WAN IP addresses and subnet masks associatedwith the connection.When using unnumbered interfaces, the Netopia Router will use either its local Ethernet IP address or itsNAT address (if so configured) and subnet mask to send packets to the remote router. Neither router has aWAN IP address or subnet mask associated with this connection.4. Select NEXT SCREEN and press Return. The IP Easy Setup screen appears.Connection Profile 1: Easy Setup ProfileConnection Profile Name: Easy Setup ProfileAddress Translation Enabled: YesIP Addressing... NumberedLocal WAN IP Address: 0.0.0.0Local WAN IP Mask: 0.0.0.0PREVIOUS SCREEN NEXT SCREENReturn accepts * ESC cancels * Left/Right moves insertion point * Del deletes.Enter basic information about your WAN connection with this screen.
