NightStick 5522-BATT Instructions Manual

NightStick 5522-BATT Instructions Manual Manual pdf 1 page image

Instructions – 5522-BATTWARNINGSy WARNING: It is recommended that a qualified technician perform the replacementof the rechargeable battery pack in this light.y WARNING: Failure to follow these instructions may impair the intrinsic safety ofthis flashlight.y WARNING: To prevent ignition of a hazardous atmosphere, do not open the lensbezel in the hazardous environment. This task must only be performed in an areaknown to be non-hazardous.y WARNING: When exchanging the rechargeable battery pack, use only theapproved 5522-BATT rechargeable battery pack from bayco products.y WARNING: To prevent ignition of a hazardous atmosphere, the rechargeablebattery pack must only be exchanged in an area known to be non-hazardous.REPLACING THE LITHIUM-ION RECHARGEABLE BATTERYy Loosen the locking screw on the side of the bezel. CAUTION: Do NOT removethe locking screw.y Unscrew the lens bezel from the housing in a counter-clockwise direction.y Loosen each of the two charger contact pins located below the Floodlight Lens.These two screws should be loosened until approximately 1/8” of thread is visible.CAUTION: Do NOT remove these two screws.y Turn the light upside down and remove the reflector/circuit assembly. CAUTION:Do NOT touch the reflector surface with your finger. Doing so may damage thereflector surface.y Remove the old 5522-BATT rechargeable battery pack paying attention to thebattery pack’s orientation within the handle. Please recycle the used battery.y Using only the approved replacement 5522-BATT rechargeable battery pack fromBayco Products, slide the new battery pack into the handle of the light using thedirectional arrow marked on the side of the pack as a guide for proper orientation.y Align the reflector/circuit assembly so that the switches on the assembly are aligned withthe switches on the housing. Fully insert the assembly back into the flashlight housing.y Tighten both of the charger contact screws fully.y Replace the lens bezel onto the housing in a clockwise direction until tight.y Tighten locking screw located on the side of the lens bezel. CAUTION: Do NOTover-tighten. Doing so may damage the threads.WARRANTY2-Year Limited Warranty. Go to www. nightstick.com for warranty information.Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 750981-800-233-2155 • 1-469-326-9400 • www.nightstick.comINS-5522-BATT-21

/ 2

Related manuals for NightStick 5522-BATT