NightStick FORGE XPP-5465 Instruction Manual

NightStick FORGE XPP-5465 Instruction Manual Manual pdf 1 page image

Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • USA • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.comINS-XPP-5465-LG-20 05-08-2020Rear Green Safety LEDThe rear green safety LED will remain lit while flashlight is on in any mode.WARRANTYLIMITED LIFETIME WARRANTYBayco Products, Inc. warrants this product to be free from defects in workmanship andmaterials for the original purchaser’s lifetime. The Limited Lifetime Warranty includes the LEDs,housing and lenses. Rechargeable batteries, chargers, switches, electronics and includedaccessories are warranted for a period of two years with proof of purchase. Normal wearand failures which are caused by accidents, misuse, abuse, faulty installation and lightningdamage are excluded.We will repair or replace this product should we determine it to be defective. This is theonly warranty, expressed or implied, including any warranty of merchantability or fi tness fora particular purpose.For a complete copy of the warranty, go to www.baycoproducts.com/nightstick-product-support/warranties. Retain your receipt for proof of purchase.Mode d’emploiForge™ XPP-5465LE XPP-5465 E ST APPROUVÉE POUR UTILISATIONAVERTISSEMENTS: SÉCURITÉ INTRINSÈQUEy Avertissement : Utiliser seulement les piles non rechargeables approuvées et énuméréesci-dessous.y Avertissement : Pour éviter l’inflammation d’atmosphère dangereuse, ne pas ouvrirle compartiment de pile dans un endroit dangereux. Cette tâche doit être effectuéeUNIQUEMENT dans une zone non dangereuse.y Avertissement : Lorsque vous remplacer les piles, utiliser uniquement les PILESENERGIZER CR123y Avertissement : Pour éviter l’inflammation d’atmosphère dangereuse, les piles doiventêtre remplacées dans une zone non dangereuse.y Avertissement : Pour réduire les risques d’explosion, ne pas mélanger les piles neuvesnon rechargeables avec des piles non rechargeables utilisées, ou mélanger les piles nonrechargeables de différents fabricants.y Avertissement : la substitution de composants peut compromettre la sécurité intrinsèque.DIRECTIVES PARTICULIÈRES POUR UNE SÉCURITÉ INTRINSÈQUEPour votre propre sécurité, toujours confi rmer la charge d’une zone dangereuse oupotentiellement dangereuse quand la lampe de poche est utilisée.Instruction ManualFORGE™ XPP-5465US PATENT 9,713,217THE XPP-5465 IS APPROVED FOR USECLASS I DIV 2 GRPS A-D T3CLASS II DIV 2 GRPS F-G T135°CCLASS I ZONE 2 Group IIC T3-20ºC ≤ Tamb ≤ +40ºC(2) CR-123 3.0V/CellINTRINSICALLY SAFESECURITE INTRINSEQUEBayco Products, Inc. XPP-5465ID 5012927640 S. Sanden Blvd., Wylie, TX 75098WARNING: Risk of ignition - Do not open in a hazardous area.AVERTISSEMENT: Ne pas ouvrir dans une zone dangereuse.WARNING: Risk of ignition - Do not change batteries in a hazardous area.AVERTISSEMENT: Danger d’inflammation - Ne changez pas les piles dans unezone dangereuse.WARNINGS - INTRINSICALLY SAFEy Warning: Use only the approved non-rechargeable batteries listed below.y Warning: Do NOT attempt to use rechargeable batteries with this light.y Warning: To prevent ignition of a hazardous atmosphere, do not open the batterycompartment in the hazardous environment. This task must ONLY be performed in anarea known to be non-hazardous.y Warning: When exchanging batteries, use only ENERGIZER CR123 lithium batteries.y Warning: To reduce the risk of explosion, do not mix new non-rechargeable batterieswith used non-rechargeable batteries, or mix non-rechargeable batteries from differentmanufacturers.y Warning: Substitution of components may impair intrinsic safety.SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETYFor personal safety, always confirm the rating of any known hazardous or potentiallyhazardous location where the light is to be used.INSTALLING BATTERIESy Loosen the screw on the battery compartment door. (Image 1)y Insert batteries using the orientation markings on the back of the battery compartmentdoor. (Image 2)y Close the battery door fully, then tightening the screw until it is hand tight. CAUTION: Donot cross-thread or strip the screw threads.y Test the operation of the light (see OPERATION below).INSTALLING ON TO A HELMETy Choose the side of the helmet you wish to mount the light on.y Rotate the mount to orient the clamp with thumbscrew on top.y Open the clamp completely and fully seat over helmet brim, ensuring the clamp clearsany rubber helmet trim. (Image 3)y Tighten the clamp firmly with included Allen wrench. (Image 4)SETTING THE ANGLE OF THE LIGHTy Twist the light left or right on the vertical pivot until beam pattern is in an ideal position.y The tension on the mount is meant to be firm to maintain the aim.y Once aimed, the mount allows the user to position light above or below the brim byrotating up or down as needed.OPERATIONThe 5465 has a flashlight push button tail switch with the following lighting modes:CONSTANT-ON FLASHLIGHTPress the fl ashlight switch until it clicks and then release for constant-on in high-brightness mode. Press and release to turn the light off.SELECT FLASHLIGHT BRIGHTNESS LEVELPress and hold down the fl ashlight switch. The fl ashlight will cycle from high to mediumto low and then back up again at a rate of approximately one mode per second. The light willcontinue to cycle through the modes as long as the fl ashlight switch is held down. When thedesired brightness level is reached, release the fl ashlight switch, and the light will remainin that mode. Press and hold from any mode to start the cycle again. Press and release toturn the light off.Image 1 Image 2 Image 3 Image 4SCAN FOR MOUNTINGINSTRUCTION VIDEOhttps://youtu.be/Ta0i7U-92hM

/ 2

Related manuals for NightStick FORGE XPP-5465