NightStick XPP-5450GC Instruction Manual
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.comINS-XPP5450GC-MH-19 02-21-2019Instruction ManualXPP-5450GCPlease read these instructions before using your Nightstick XPP-5450GCIntrinsically Safe Headlamp. They include important safety information andoperating instructions.THE XPP-5450GC IS APPROVED FOR USECLASS I DIV 1 GRPS A-D T3CLASS II & III GRPS E-G T135CCLASS I ZONE 0 AEx ia IIC T3 GaCLASS I ZONE 0 Ex ia IIC T3 GaII 1 G Ex ia op is IIC T3 GaEx ia op is IIC T3 GaIntertek ITS 13 ATEX27854XIECEx ITS 17.0002X-20ºC ≤ Tamb ≤ +40ºC1.5V/Cell AAA Alkaline0359ID 4001184INTRINSICALLY SAFESECURITE INTRINSEQUEBayco Products, Inc. XPP-5450GCWylie, TX 75098640 S. Sanden Blvd.WARNINGS - INTRINSICALLY SAFEy Warning: Use only the approved non-rechargeable batteries listed below.y Warning: Do NOT attempt to use rechargeable AAA batteries with this light.y Warning: To prevent ignition of a hazardous atmosphere, do not open thebattery compartment in the hazardous environment. This task must ONLYbe performed in an area known to be non-hazardous.y Warning: When exchanging batteries, use only ENERGIZER E92 or EN92BATTERIES.y Warning: To prevent ignition of a hazardous atmosphere, the AAA batteriesmust only be exchanged in an area known to be non-hazardous.y Warning: To reduce the risk of explosion, do not mix new non-rechargeablebatteries with used non-rechargeable batteries, or mix non-rechargeablebatteries from different manufacturers.y Warning: Substitution of components may impair intrinsic safety.SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETYy For personal safety, always confirm the rating of any known hazardous orpotentially hazardous location where the light is to be used.BATTERY INSTALLATIONWARNING: In order to maintain the XPP-5450GC’s Intrinsically Saferating, the only AAA batteries certified for use with this light are theENERGIZER E92 or EN92 BATTERIES.y Do not attempt to use any other brand or model of AAA batteries with this light.y Do not attempt to use any type of rechargeable AAA batteries with this light.Warning: To prevent ignition of a hazardous atmosphere, do not openthe battery compartment door in the hazardous environment. This taskmust ONLY be done in an area known to be non-hazardous.y Loosen the locking screw located on the back of the battery compartmentdoor. NOTE: Do NOT attempt to completely remove the locking screw.Doing so is not necessary and may damage the threads. The screw simplyneeds to be loosened enough to allow the battery compartment door to open.y Using 3 – AAA ENERGIZER E92 or EN92 BATTERIES (make sure thatall 3 batteries are of the same model), install the batteries in the back of thelight paying close attention to the markings inside the battery compartmentfor proper battery terminal polarity alignment.y Close the battery compartment door.y Tighten locking screw. CAUTION: Do NOT over-tighten. Doing so maydamage the threads and impact the light’s Intrinsic Safety.OPERATIONTHE XPP-5450GC HAS TWO SEPARATE LIGHTING MODES:y High-brightness Spotlighty Low-brightness SpotlightHIGH-BRIGHTNESS SPOTLIGHT MODEPress the button on top of the light one time.LOW-BRIGHTNESS SPOTLIGHT MODEPress the button on top of the light two times. Pressing the button a thirdtime will turn the light off.THE XPP-5450GC HAS A TILT ADJUSTMENT FEATURE:Simply adjust the tilt angle of the light to illuminate the desired area.THE XPP-5450GC FITS ON ANY HARD HAT THAT HAS A HARD HATLAMP BRACKET ATTACHED:NIGHTSTICK NS-HMC4 HEADLAMP BRACKET MOUNTINGINSTRUCTIONSy Ensure mounting surface is clean and oil-free (use alcohol wipe if needed)y Prior to installing, determine mounting location that allows headlamp tofully tilt without interfering with helmet brim.y Remove adhesive backing.y Firmly press bracket into place up for 30 seconds with flat side facing up(see image).y While supporting mount, slide headlamp clip into bracket slot. (Note:adhesive reaches peak strength in 24 hours)TO ATTACH TO THE HARD HAT LAMP BRACKETSlide the clip on the back of the XPP-5450GC into the slot on the topedge of the Hard Hat Lamp Bracket and press down firmly until the clip is fullyengaged into the bracket.TO REMOVE FROM THE HARD HAT LAMP BRACKETGrasp the XPP-5450GC and pull up until the clip slides out of the HardHat Lamp Bracket.WARRANTYLIMITED LIFETIME WARRANTYBayco Products, Inc. warrants this product to be free from defects inworkmanship and materials for the original purchaser’s lifetime. The LimitedLifetime Warranty includes the LEDs, housing and lenses. Rechargeablebatteries, chargers, switches, electronics and included accessories arewarranted for a period of two years with proof of purchase. Normal wear andfailures which are caused by accidents, misuse, abuse, faulty installation andlightning damage are excluded.We will repair or replace this product should we determine it to bedefective. This is the only warranty, expressed or implied, including anywarranty of merchantability or fitness for a particular purpose.For a complete copy of the warranty, go to www.nightstick.com/nightstick-product-support/warranties. Retain your receipt for proof of purchase. |
Related manuals for NightStick XPP-5450GC
NightStick XPP-5450G Instruction Manual
NightStick XPP-5452GC Instruction Manual
NightStick XPP-5454GC Instruction Manual
NightStick XPP-5454GC Instruction Manual
NightStick XPP-5458G Instruction Manual
NightStick XPP-5454G Instruction Manual
NightStick XPP-5452G Instruction Manual
NightStick XPP-5452G Instruction Manual
NightStick XPP-5456G Instruction Manual
NightStick XPP-5454G Instruction Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine