Nikon COOLPIX S6 User Manual

Contents

96Technical NotesDisplay Problem SolutionSYSTEM ERRORError has occurred incamera’s internal cir-cuitry.Turn camera off, remove and reinsertbatteries, and turn camera on. If errorpersists, contact retailer or Nikon rep-resentative.14PRINTER ERRORCHECK PRINTER STATUS Printer error. Check printer. To resume, highlightResume (if available) and press . —TroubleshootingIf the camera fails to function as expected, check the list of common problemsbelow before consulting your retailer or Nikon representative. Refer to the pagenumbers in the right-most column for more information.Problem SolutionCamera turns offwithout warning• Battery is low.• Camera has turned off automatically to save power.• Battery is cold.1414106Monitor is blank• Camera is off.• Battery is exhausted.• Standby mode: monitor turns on when controls are used.• Flash lamp blinks red: wait until fl ash has charged.• USB cable is connected.• A/V cable is connected.• Time lapse or interval timer photography in progress: mon-itor turns off automatically between shots1414142055, 585436, 77No indicators appearin monitor Hide info is selected for Photo info. Select Show info. 86Monitor is hard toread• Monitor has dimmed to save power: monitor brightenswhen controls are used.• Adjust monitor brightness.• Monitor is dirty: clean monitor.148692In extremely rare instances, unusual characters may appear in the monitor and the cam-era may stop functioning. In most cases, this phenomenon is caused by a strong externalstatic charge. Turn the camera off, remove and replace the batteries, and then turn thecamera on again. In the event of continued malfunction, contact your retailer or Nikonrepresentative. Note that disconnecting the power source as described above may resultin the loss of any data not recorded to internal memory or the memory card at the timethe problem occurred. Data already recorded will not be affected.Electronically Controlled Cameras