582 Remove finger from ¨ button, and rotate Main-Command Dial to select desired shutter speed.Shutter speed indications change in 1/3 steps between 30 sec.and 1/8000 sec., and flash sync speed of 1/250 sec. (X25o).• This operation can be performed only with lenses havinga built-in CPU.• If meter and LCD readout have turned off, turn on againby lightly pressing shutter release button.• If “bulb” is set on the camera, selecting the Shutter-Priority Auto mode will cause buLb to blink—a warningthat the “bulb” setting cannot be used in Shutter-Prioritymode.SHOOTING IN EACH EXPOSURE MODEOperation in Shutter-Priority Auto Exposure Mode1 While pressing ¨ button, rotate Main-Command Dialuntil ™ appears in the top LCD panel and S in theviewfinder.• When using CPU Nikkor lens other than G-type, make sure toset lens to its minimum aperture position (largest f-number).c The direction that the Main-CommandDial is turned to increase/decreaseshutter speed can be changed using Custom Setting #6.See page 88.P400 (E) 02.12.27 6:42 PM Page 58
