131TroubleshootingShould you encounter problems with your scanner, refer to the following section and the trouble-shooting section in the Nikon Scan Reference Manual before consulting your retailer or Nikonrepresentative.Problem Possible Cause60Holders can not be insertedor removed• The sliding cover is not fully openSlide the cover down until it is fully open.2526–The scanner does not turnon (the status LED does notlight)• The power cable is not properly connectedAfter confirming that the scanner is off, reconnect the powercable.• The scanner is offTurn the scanner on.• The power supply to scanner has been interruptedTry plugging a different device into the outlet used by thescanner to determine whether the problem is caused by afailed fuse or circuit breaker.–The status LED flashesrapidly (scanner not con-nected to computer orcomputer off)• A scanner hardware malfunction has occurredTurn the scanner off and disconnect it from the computer.Wait five seconds, then turn the scanner on again. If theproblem persists, contact your retailer or Nikon service rep-resentative for advice.
