INSTRUCTION MANUALDocument ID: 73-H001. Copyright © Nilar AB. All rights reserved. Page 20 (32)6.4.7 Address settingThe address is set in the production of battery pack atthe Nilar factory.No action is required during installation.6.4.8 Mounting of IMU cover lidMount the cover lid back on the IMU by tightening thetwo (2) torx screws size 20 with a screwdriver (seesection 6.4.1)6.4.9 Check of cable entryCheck that all cables are correctly situated through thecable entry in the bottom of the cover lid.Figure 35: Detail view of Cable entry on cover lid of IMU6.4.11 Installation of negative terminal cablePlug in the negative (-) cable connector, type Phoenix1774687 into the negative (-) chassis connector, typePhoenix 1805177 (see section 4.2.1)Indicated as blue (●) in the following figure.Figure 36: Installation of negative (-) cable, prior to connection (IMU connectionsnot displayed)Figure 37: Installation of negative (-) cable, after connection (IMU connectionsnot displayed)
