Nilfisk-Advance Supreme 100 Instructions For Use Manual

Also see for Supreme 100: Instructions for use manual Instructions for use Instructions for use

Contents

Nilfisk-Advance Supreme 100 Instructions For Use Manual Manual pdf 12 page image

127 Filter and dust bags - Supreme 150 / Supreme 250 / Supreme LCD7.3 Replacing the dust bagThe machine is supplied with a dust bag. Replace the dustbag in the following way:1. Release the two handles clamped on to the dustcontainer. The handles are easily unlocked by liftingup the handles until they come to a stop. When youpull the handles outwards away from the cleaner, thecontainer is released. Fig. 24.2. Lift off the container.3. Shake the dust from the bag filter. It may be advanta-geous for the filter to be installed in the container insuch a way that dust in the filter can be shaken downinto the dust container.4. Lift out the bag filter.5. Remove the dust bag by taking hold of the cardboardstiffener and carefully pulling out the card and bagfrom the container, Fig. 26. Fold down the perforatedpart of the cardboard towards the opening of the bagin order to prevent the bag contents to leak out.6. Empty the container of dust.7.1 Replacing the bag fi lterA bag filter must always be installed in the dust container.Clean the filter in the following way:1. Release the two handles clamping the dust container.The handles are easily unlocked by lifting up thehandles until they come to a stop. When you pull thehandles outwards away from the cleaner, the contain-er is released. Fig. 24.2. Do not remove the filter from the container. Instead,give the filter a light shaking inside the container toloosen dust from the filter allowing it to fall into thecontainer. This is done by grasping the strap on the fil-ter and quickly move the filter up and down as shownin Fig. 25.3. Lift out the bag filter. If a dust bag is being used - re-move the dust bag. Then empty the container of anyremaining dust in a suitable place.7.2 Fitting the bag fi lterReplace the bag filter in the machine as follows:1. Replace the cleaned/shaken bag filter in the container. Makesure the filter support fits into the inner edge of the dustcontainer properly. Check that the filter is fitted the right wayup - the cloth handle on the filter should be visible.2. Then replace the dust container with the bag filter in thecleaner’s vacuum unit.3. Attach the container on the vacuum unit by lifting the con-tainer back in place and pushing the handles back in overthe edge of the cleaner till you hear a click. Push down thehandles and ensure that the vacuum unit and dust containerare fitted together properly.7.4 Fitting the dust bagReplace the dust bag as follows:1. Fit the dust bag’s card with a hole into the bag holder,Fig. 27.2. Replace the cleaned/shaken bag filter in the contain-er. Make sure the filter support fits into the inner edgeof the dust container properly.Check that the filter is fitted the right way up - thecloth handle on the filter should be visible.3. Replace the dust container on the vacuum unit. Closethe container on the vacuum unit by applying inwardpressure to the two handles to ensure the vacuumunit and dust container are fitted together properly.Fig. 24 Fig. 25Fig. 27Fig. 26The Supreme 150 / Supreme 250 / Supreme LCD canbe run with or without the installation of a dust bag- the choice is yours. These products must thoughalways be operated with the bag filter fi tted in thecleaner.