Nilfisk-Advance Supreme 100 Instructions For Use Manual

Also see for Supreme 100: Instructions for use manual Instructions for use Instructions for use

Contents

Nilfisk-Advance Supreme 100 Instructions For Use Manual Manual pdf 6 page image

62.1 Fitting the wall bracketPosition the holder so that there is plenty of space above andbelow the place where the vacuum unit is to be located. Makesure there is a minimum of 500 mm free space above thecontainer. Mark the positions for the four screw holes with apen or similar. Then select appropriate screws and, if neces-sary, wall plugs for the type of wall surface to which the brack-et is to be attached. Drill the four holes for the wall bracket.The diameter of the screw holes in the holder is 5 mm. Fit thewall bracket with the large opening pointing upwards, see Fig.1. Tighten the screws so that the holder is held firmly in place(screws provided).2.3 Connecting the machineThe machine is connected with the suction pipe in the uppermost position and theexhaust pipe in the lower position.This connection should not be glued but can be taped when the unit is servicedat a later date. The suction pipe socket can be fi tted to two different pointsdepending on the direction in which you would like to install the pipe system.To relocate the suction pipe socket, you need to do the following:1. Release the suction pipe socket by unscrewing the four combination Torx screwswith a Torx T20 or an ordinary screwdriver, Fig. 3.2. Pull the socket out of the machine, see Fig. 4.3. Loosen the plug blanking off the outlet to which you intend moving the suction pipesocket. Unscrew the four combination Torx screws. Remove the blanking plug fromthe machine.4. Adapt (move) the suction pipe socket to the new outlet. NB! The socket is marked ”Up”. Make sure the socket is fit-ted with ”Up” uppermost. Fasten the socket by fitting and tightening the four screws, Fig. 5.5. Fit the blanking plug to the outlet previously occupied by the suction pipe socket. Use the four screws to hold it inplace. The exhaust pipe must be firmly attached to the wall to ensure its connection with the socket does not loosen.Remember that you will need to be able to turn the bent pipe in different directions to ensure a suitable pipe layout.Then connect up the exhaust pipe and muffler, Fig 6. Fit the central vacuum cleaner so that the exhaust pipe is asshort as possible, max. 5 metres. Take the surroundings into consideration when positioning the exhaust. For thisreason, you should always fit a muffler.For additional information concerning the assembly and installation of the pipe system and low-current lead, pleaserefer to the separate assembly instructions supplied with the pipe package.2 Vacuum unit Supreme 100 assembly instructions2.2 Locating the vacuum cleaner on thewall bracketPosition the vacuum unit so that the wall bracket is direct-ly above the wall bracket, see Fig. 2. Lower the machinedown on to the wall bracket. Make sure the correspondingbracket on the machine is held firmly in place by the wallbracket.Fig. 1 Fig. 2Fig. 3 Fig. 4 Fig. 5ExhaustInletFig. 6