84.1 Replacing the dust bagThe central vacuum cleaner is fitted with a dust bag asstandard; never vacuum without a dust bag installed.Replacing the dust bag: Grasp the edge of the lid andpull upwards to open it, Fig. 12. Remove the old dust bagby turning the cardboard stiffener to the right or left so thatthe raised part of the inlet is in line with the opening in thecard. Now slide the bag off the bag nozzle.Fit the new dust bag as follows: Push the opening inthe cardboard over the elevation on the inlet and pull onthe new bag. Turn the cardboard to lock the bag in place.NB! Turn the edges of the dust bag down into the contain-er. This is to avoid damaging the bag with the lid.The cardboard stiffener locks the bag in place when you twist itas shown in Fig. 13 above.The opening in the card must line up and slide over the elevationon the inlet before you twist the cardboard stiffener to lock it.4.2 Replacing / cleaning the filterOpen the lid and take out the dust bag as described earli-er. The filter sits at the bottom of the container around themotor housing. Never use the central vacuum cleanerwithout a filter installed.Replacing the filter:Pull the filter out of the container, Fig. 14. The filter can becleaned by shaking it or washing it in water.If you wash the filter, you must let it dry completelybefore refitting it.Fit the fi lter as follows: Take the cleaned/new filter andplace it in the bottom of the container. Press the outeredge of the filter down against the sides of the containerso that the filter bulges up slightly. Then push the filterdown into place. Make sure the filter is packed in tightlyagainst the motor housing, Fig. 15. Reinstall the dust bagand replace the lid. Check that the lid is firmly secured.4 Filter and dust bags - Supreme 100FilterFilterMotor housingFig. 15Fig. 13Fig. 14Fig. 12