Trunk Outgoing Call 3-1 !!!! Specified Trunk AccessDESCRIPTION:Trunk (CO/PBX) lines can be grouped into a maximum of 30 groups. The line groups assigned to eachextension can be used for outgoing calls. Up to two outgoing line groups can be assigned to anextension. An extension user can place outside calls on a particular line group by pressing Line key ordialing line number.STATION APPLICATION:KTS, SLTOPERATION:To make an outside call on a particular line:When the trunk line appears under a Line key:1. Lift handset or press SPK key.2. Press a Line key. Hear dial tone.3. Dial telephone number.When the trunk line does not appear under a Line key:1. Lift handset or press SPK key. (See Note 1)2. Dial 9.3. Dial two-digit line number. Hear dial tone.4. Dial telephone number.1. Lift handset. Listen for dial tone.2. Dial 0 or 9. (See Note 2)3. Dial two-digit line number. Hear dial tone.4. Dial telephone number.Note 1: If Program #075-Item4 is 0 (No tone), press ICM key after Step 1 to seize Intercom.Note 2:Program #020-Item4 Data Automatic Trunk Access Code for SLT Dial at Step 20 0 91 9 0Note 3: Easy Trunk Access, Queuing Group Access, Loop Key Trunk Access, Automatic Off-Hook Trunk Accessfeatures provide other ways to access a Trunk Line.RELATED SYSTEM DATA:#002: Line Group Assignment#003-Item3: Common Use Line Assignment#006: Outgoing Line Access#075-Item4: KTS Off-Hook Mode Selection" Single Step AccessDESCRIPTION:Single Step Access allows a key telephone user to obtain outside or intercom dial tone for an outgoingcall in a single step, without lifting the handset or pressing the SPK key.STATION APPLICATION:KTS
