Nivus OCM PRO CF Instruction Manual

Also see for OCM PRO CF: Instruction manual

Contents

Nivus OCM PRO CF Instruction Manual Manual pdf 59 page image

Instruction ManualOCM Pro CF®OCM Pro CF - Rev. 07 as of 04.12.2012 Page 597 Initial Start-Up7.1 GeneralNotes to the userBefore you connect and operate the OCM Pro CF you should strictly follow thenotes below!This instruction manual contains all necessary information to program and tooperate the device, addressing qualified technical staff who have appropriateknowledge about measurement technology, automation technology, informationtechnology and waste water hydraulics.To ensure a correct function of the OCM Pro CF this instruction manual must beread thoroughly!The OCM Pro CF must be wired in accordance with the wiring diagram, seechapter 6.2.4If any problems regarding installation, connection or programming should occurplease contact our hotline or the NIVUS start-up service.General PrinciplesThe initial start-up is not allowed until the installation has been finished andchecked.To exclude faulty programming this instruction manual must be read before theinitial start-up.Please get familiar with the OCM Pro CF programming via display and keyboardby reading the instruction manual before you begin to program the device.After transmitter and sensors are connected (see chapters 6.2 and 6.3) the pa-rameters must be set. In the most cases all you need is:- geometry of the measurement place and dimensions- used sensors and positioning- display units- span and function of analog and digital outputsThe OCM Pro CF user surface has been designed in a way which allows evenunfamiliar users to easily set up basic settings in graphic dialog mode ensuringreliable device operation.For extensive programming, difficult hydraulic conditions, special channelshapes, in case of absence of expert staff or if a setup and error protocol is re-quired, the programming should be carried out by the manufacturer or an expertcompany which is authorised by the manufacturer.