Noblelift FE4P44-77N Series Operation And Maintenance Manual

Also see for FE4P16N: Operation and maintenance manual

Contents

Noblelift FE4P44-77N Series Operation And Maintenance Manual Manual pdf 30 page image

29(3) Wheel hubWheel Hub is fitted on kunckle by taper bearing, wheel is fitted on wheel hub by wheel rim,there is oil seal inside of bearing to keep lubricate greese in cavity of wheel hub and kunckle.There is nut to adjust bearing for elasticity.3.4 Gist for adjustment and maintenance(1) See figure 2-38, lubricate inner cavity of wheel hub, inside or outside bearing and coverof wheel hub, meanwhile, lubricate oil seal(2) Fit bearing outer ring on wheel hub and fit wheel hub on kunckle shaft.(3) Fit washer and tighten castle nut, its tightening torque is 206-235N.m(21-24kgm),thenloose castle nut, tightening nut again, at this time, the torque is 9.8N.m(1kgm)(4) Tap wheel hub gently by wood hammer and rotate wheel hub 3-4 circle to ensure there isno loose of wheel hub.(5) Tighten castle nut and make slot aim at split pin hole of kunckle(6) Tap wheel hub gently by wood hammer again, rotate wheel hub 3-4 circle by hand toensure rotation stability, and measure rotation torque to ensure it between2.94-7.8N．m(0.3-0.8kgm)(7)；If rotation torque is more than standard value, you can untread 1／6 circle and thenmeasure rotation torque again.(8) After rotation torque is regulated at its standard value, lock castle nut by split pinfigure 2-38 Adjustment for pretightening force3.5 Inspection after rebuilding of steering system(1) Run steering wheel right and left to its end to check if its running is uniformity andstability(2) Check up laying out of hydraulic pipeline and direction changing for mislayingJack rear wheel up, running steering wheel right and left slowly, repeating several times, exhaustair out of hydraulic pipeline and oil cylinderinfuse lubricate grease