61backrest or rigidity loading goods frame, or low lift height.5. Transporting and loading for forklift(1) Transportation of forklift·Transporting with truck,Wedge forklift wheel or tighten forklift by rope to prevent itmoving during transportation.·Pay attention to obey regulation of full-length, full-width, full-height of forklift duringtransportation on traffic road.(2) Loading and unloading for forklift·Please use gangplank with enough length, width and intensity.·Brake lorry firmly and wedge wheel.·Gangplank shall be fixed on middle of carriage firmly, no greese on gangplank.·Both height of left and right gangplank shall be same.·Do not turn or transverse move during operating ongangplank.·When loading on lorry, in order to let forklift board onsimultaneously, please backing lorry slowly.6. Preparation before driving(1) Check position of direction switch handle⑤,and push it toneutral position(N).(2) Turn on ignition keyCatch hold of handle of steering wheel,then turn on ignition keyand keep it at “ON”position.·Even after ignition key is turned to “ON”position,1 second is needed between brakecircuit starting to work and starting to move.·If gear shift lever is in forwardposition“F” orbackwardposition“R”,before turn ignition key to“on”position,pushgear shift lever to neutral position“N”·Do notice that if step down accelerating paddlesuddenly,vehicle will probably accelerate suddenly.(3) Tilting backward of mastPull backward lifting handle to lift fork150-200mm upto ground,and pull backward tilting handle to tilt mastbackward.(4) Operation of direction switch handle⑤Direction switch handle decide travelling direction(forward-backward)Forward F:push forward direction switch handleBackward R:pull backward direction switch handle(5) Loosen parking brake handleStep down brake paddleLet go parking brake handle forward entirely,catch hold of steering wheel with left hand,putright hand lightly on steering wheel too.7. Steer(1) Starting upMove food away from brake paddle and step downaccelerating paddle slowly,then,the vehicle will start tomove.Acceleration rate is decided by how muchaccelerating paddle is stepped down.