Noblelift FE4P44-77N Series Operation And Maintenance Manual

Also see for FE4P16N: Operation and maintenance manual

Contents

Noblelift FE4P44-77N Series Operation And Maintenance Manual Manual pdf 7 page image

6(11) No operation of truck and it’s additions without sitting on the driver’s seat(12) Push handle immediately to middle position when the mast has tilted forward orbackward to the extreme position(13) No driving or turning when the mast is lifting(14) When travelling,pay attention to passers by,obstacles,irregular road and the clearance ofupper side of forklift(15) Be careful of travelling on slope,when the angle of slope is more than10%,travel forwardupslope and travel backward downslope. no turning on slope,no loading or unloading whentravelling downslope（16）Reduce speed when turning on the damp or slick road,take special care and drive slowlywhen travelling on dock or on temporary board(17) Operating high lift range truck of which the lifting height is more than 3m,pay attention tothe dropping of the load,and take measures to prevent it when necessary(18) Don’t convey unfastened or loosely stacked load,be caref when conveying large-sizeload(19) When travelling with load,avoid emergency brake(20) When leaving the truck,lower the forks to ground;push lever to free position,switch offpower,when parking on the slope,pull tight the brake apparatus and plug the wheels with wedge ifthe parking time is long(21) The protection valves on multiway valve and on steering device are already regulated,sothe users shouldn’t regulate randomly when using to prevent that the excessively high oil pressureleads to the damage of the whole hydraulic system and the burnout of the electric motor(22) Charge the tyres according to the pressure value stated in “tire pressure” indication(23) Treat the operation of non-load truck with additional apparatus as the operation loadtruck5 Battery charging(1) In the first time of charging or boost charging of battery,act strictly according to the rulesstated in battery specification(2) When the truck is in working,and when the battery voltage drops to 41V or any one of thecells voltage drops to 1.7V or the meter alarms,stop working immediately,charge the battery orchange another fully charged battery(3) Inspect at any moment the density,the level and the temperature of electrolyte whencharge the battery(4) Charge the battery at once after use of the truck,the storage period should be less than24h;in order not to damage the battery,prevent under charging or over charging of the battery(5) In order to adjust the density of each cell,make a equalizing charge of the battery inregular service once a month,please refer to the related chapter to get the details of the chargingmethod and usage maintenance