Follow the instructions from your service provider.● Access point name — You obtain the accesspoint name from your service provider.● User name — The user name may be needed tomake a data connection, and is usually providedby the service provider.● Prompt password — If you must enter thepassword every time you log in to a server, or ifyou do not want to save your password in thedevice, select Yes.● Password — A password may be needed tomake a data connection and is usually providedby the service provider.● Authentication — Select Secure to always sendyour password encrypted or Normal to sendyour password encrypted when possible.● Homepage — Depending on the access pointyou are setting up, enter the web address or theaddress of the multimedia messaging centre.Select Options > Advanced settings to changethe following settings:● Network type — Select the internet protocoltype to transfer data to and from your device. Theother settings depend on the selected networktype.● Phone IP address (for IPV4 only) — Enter the IPaddress of your device.● DNS address — Enter the IP addresses of theprimary and secondary DNS servers, if requiredby your service provider. Contact your internetservice provider to obtain these addresses.● Proxy server address — Enter the address ofthe proxy server.● Proxy port number — Enter the port numberof the proxy server.WLAN internet access pointsPress , and select Tools > Settings >Connection > Access points > Options > Editor New access point.Follow the instructions from the WLAN serviceprovider.● WLAN network name — Select Entermanually or Search for networks. If you selectan existing network, WLAN network mode andWLAN security mode are determined by thesettings of its access point device.● Network status — Define whether the networkname is displayed.● WLAN network mode — Select Ad-hoc tocreate an ad hoc network and to allow devices tosend and receive data directly; a WLAN accesspoint device is not needed. In an ad hoc network,all devices must use the same WLAN networkname.● WLAN security mode — Select the encryptionused: WEP, 802.1x (not for ad hoc networks), orWPA/WPA2. If you select Open network, no 151 Settings
