Nokia 1500S User Manual

Nokia 1500S User Manual Manual pdf 17 page image

GB 17Motor antenna configurationIf you have an antenna motor to control your satellite antenna you must configurethe following settings.• From the “Antenna/Satellite selection” menu select option 3 “Motor AntennaConfiguration” and press select.Type of motor• Select SATSCAN (ASTRA) if you have a Nokia SatScan motor.• Select DiSEqC (Hotbird) if the motor that you have is controlled by DiSEqC com-mands.LNB type• Select the correct LNB type for your configuration, e.g. “Universal”.LNB offset voltageIf the cable from the antenna is very long, the voltage to the LNB could be toolow to change the polarisation. You can increase the voltage to the LNB by 0.5 V.Predefined ASTRA-/HOTBIRD-channel• Select one of the predefined channels and adjust the antenna until a TV pic-ture from the predefined channel is visible on the screen.Adjusting the motor for ASTRA/HOTBIRDTo continue the installation you must now determine the angle toASTRA 1 or HOTBIRD. The motor and the antenna must be adjusted to-wards the ASTRA 1 satellites at 19.2∞ East or HOTBIRD satellites at 13∞East as this is the reference setting. All other pre-programmed satellitepositions are oriented relative to ASTRA 1 or Hotbird.You must also mount the antenna in a suitable location outdoors.For more information, please read the separate installation instructionsfor the SatScan or DiSEqC positioner.East and West limit set-upNote! You only have to set one or both of these limits if the antenna is preventedfrom reaching its East/West limit positions. This could be the case,for example, ifthe antenna is mounted too close to a wall or in any similar situation.To set these limits, adjust the antenna using the cursor left/cursor right button.• Firstly, move the antenna to the east limit.• Then move the antenna to the west limit.• Press select to confirm all settings and carry out the channel search procedure.First time installation