173. To end the call or to cancel the call attempt, press the end key, or close the phone.To find a name or phone number that you saved in Phonebook, see “Find a contact,” p. 44.Press the call key to call the number.To access the list of dialed numbers, press the call key once in the standby mode. To call anumber, select a number or name, and press the call key.1-touch dialingAssign a phone number to one of the 1-touch-dialing keys, 2 to 9. See “1 touch-dialing,”p. 46. Call the number in either of the following ways:• Press a 1-touch-dialing key, then the call key.• If 1-touch dialing is set to On, press and hold a 1-touch-dialing key until the call begins.See 1-touch dialing in “Call,” p. 52.Enhanced voice dialingTo make a phone call, say the name that is saved in the contact list of the phone. Voicecommands are language-dependent. To set the language, see Language settings >Recognition lang. in “Phone,” p. 52.Note: Using voice tags may be difficult in a noisy environment or during anemergency, so you should not rely solely upon voice dialing in all circumstances.1. In the standby mode, press and hold the right selection key or press and hold the volumedown key. A short tone is played, and Speak now is displayed.2. Say the voice command clearly. If the voice recognition was successful, a list withmatches is shown. The phone plays the voice command of the match on the top of thelist. If the result is not the correct one, scroll to another entry.Using voice commands to carry out a selected phone function is similar to voice dialing.See Voice commands in “My shortcuts,” p. 48.■ Answer or decline a callTo answer an incoming call, press the call key, or open the phone.To end the call, press the end key or close the phone.To decline an incoming call, press the end key or close the phone.To decline an incoming call when the phone is closed, press and hold a volume key.To mute the ringing tone, press a volume key when the phone is closed, or select Silencewhen the phone is open.When receiving a call with the phone open, select Options > Loudspeaker, Answer, or Decline.