Connectivity80Send dataThere can be only one active Bluetooth connection at a time.1 Open an application where the item you wish to sendis stored. For example, to send an image to anothercompatible device, select Gallery.2 Select the item (for example, an image) and Options >Send > Via Bluetooth.Tip! When searching for devices, some devicesmay show only the unique addresses (deviceaddresses). To find the unique address of yourphone, enter the code *#2820# in thestandby mode.The phone starts to search for devices within range.Devices with Bluetooth technology that are withinrange start to appear on the display one by one. Youcan see a device icon, the name of the device, thedevice type, or a short name.Tip! If you have searched for devices earlier, alist of the devices that were found previously isshown first. To start a new search, select Moredevices. If you switch off the phone, the listis cleared.To interrupt the search, select Stop. The device listfreezes, and you can start to form a connection to oneof the devices already found.3 Select the device with which you want to connect.4 If the other device requires pairing before data can betransmitted, a tone sounds, and you are asked to entera passcode.Create your own passcode (1–16 digits), and agree withthe owner of the other device to use the same code. Thepasscode is used only once.Tip! To send text using a Bluetooth connection(instead of text messages), select Notes,write the text, and select Options > Send >Via Bluetooth.After pairing, the device is saved to the paireddevices view.Pairing means authentication. The users of the devices withBluetooth technology should agree what the passcode isand use the same passcode for both devices in order to pairthem. Devices that do not have a user interface have afactory-set passcode.When the connection has been established, Sending datais shown.The Sent folder in Messaging does not store messages sentusing a Bluetooth connection.