ANSI Hardware Installation Manual Installing cards in the 7360 ISAM FX-12 shelfIssue: 09 3HH-12893-AAAA-TCZZA 197DRAFT11.4 Recommended toolsThe following tools are recommended:• screwdriver to secure cards• antistatic wrist strap for handling cards with ESD sensitive devices• ohmmeter to check connection of wrist strap to earth bounding point11.5 Guideline for card installationThis section provides a general guideline for the correct installation of a card in ashelf.Procedure 39 Installing a dummy front panelTo install a dummy front panel:1 Gently plug the card in the 7360 ISAM FX shelf until the front panel of the card touches theshelf. Guide the card to the right of the slot in the shelf card guides, while taking care that theSMD components of the card do not touch the card mounted below.2 For dummy front panels equipped with ejector handles:• Pull back the ejector handles.• Place left thumb at the left of the front panel, next to the mnemonic label, and place rightthumb on the front panel below the right ejector handle.• Push with the left thumb and guide with the right thumb. The ejector handles should moveinward.• Push both ejector handles simultaneously to completely insert the card in the shelf slot.• Lock the card in place by fastening the fixation screws.3 For dummy panels not equipped with ejector handles:• Align the dummy front panel to the 7360 ISAM FX shelf LT slot, ensuring that the dummyfront panel thumbscrews are aligned to the shelf screw holes.• Hand tighten the thumbscrews. Fully secure thumbscrews using screwdriver.4 If the installed dummy front panel supports pre-cabling:• Attach the cables to the faceplate by aligning the MDF or POTS cable head shell screwswith the faceplate standoffs, and secure the cable by tightening the connector screwsusing a screwdriver.
