• WLAN security mode — You must select thesame security mode that is used in the WLANaccess point. If you select WEP (wired equivalentprivacy), 802.1x, or WPA/WPA2 (Wi-Fi protectedaccess), you must also configure the relevantadditional settings.• WLAN security settings — Edit the securitysettings for the selected security mode.• Homepage — Enter the web address of thepage you want to display as the home pagewhen you use this access point.To set up a WLAN access point automatically, use theWLAN wizard. Select Menu > Connectivity > WLANwiz..Advanced access pointsettings for WLANSelect Menu > Tools > Settings > Connection >Access points.After setting up a basic access point for WLAN, selectOptions > Advanced settings, and define thefollowing advanced settings:• IPv4 settings — Enter the device IP and nameserver addresses for the IPv4 internet protocol.• IPv6 settings — Select or enter the name serveraddresses for the IPv6 internet protocol.• Ad-hoc channel — The channel is usually chosenautomatically. To enter the channel number (1-11)manually, select User defined.• Proxy server address — Enter the proxy serveraddress.• Proxy port number — Enter the proxy server portnumber.Connect PC to webYou can use your device to connect your PC to the web.1. Connect the data cable to the USB connectors ofyour device and your PC.2. Select Connect PC to web. The necessary softwareis automatically installed from your device to thePC.3. Accept the installation in your PC. Accept also theconnection, if prompted. When the connection tothe web is established, the web browser of your PCopens.You must have administrator rights to your PC, and theautorun option enabled in the PC.57 Internet
