encryption is used. The WEP, 802.1x, and WPAfunctions can be used only if the networksupports them.To enter the settings for the selected security mode,select WLAN security settings.Security settings for WEP● WEP key in use — Select the wired equivalentprivacy (WEP) key number. You can create up tofour WEP keys. The same settings must beentered on the WLAN access point device.● Authentication type — Select Open orShared for the authentication type betweenyour device and the WLAN access point device.● WEP key settings — Enter WEP encryption(length of the key), WEP key format (ASCII orHexadecimal), and WEP key (the WEP key datain the selected format).Security settings for 802.1x and WPA/WPA2● WPA/WPA2 — Select the means ofauthentication: EAP to use an extensibleauthentication protocol (EAP) plug-in, or Pre-shared key to use a password. Complete theappropriate settings:● EAP plug-in settings — Enter the settings asyour service provider instructs.● Pre-shared key — Enter a password. Thesame password must be entered on the WLANaccess point device.● WPA2 only mode — Only WPA2 enabled devicesare allowed to establish a connection in thismode.Advanced WLAN settingsSelect Options > Advanced settings and from thefollowing:● IPv4 settings — Enter the IP address of yourdevice, the subnet IP address, the defaultgateway, and the IP addresses of the primary andsecondary DNS servers. Contact your internetservice provider for these addresses.● IPv6 settings — Define the type of DNS address.● Ad-hoc channel (only for Ad-hoc) — To enter achannel number (1-11) manually, select Userdefined.● Proxy server address — Enter the address forthe proxy server.● Proxy port number — Enter the proxy portnumber.Packet data settingsPress , and select Tools > Settings >Connection > Packet data.The packet data settings affect all access pointsusing a packet data connection.● Packet data connection — If you select Whenavailable and you are in a network that supportspacket data, the device registers to the packet150 Settings
