access point cannot be used for this service. Thepacket data internet access point is asked when GPSis used for the first time in your device.To enable or disable different positioning methods,such as Bluetooth GPS, press , and select Tools >Settings > General > Positioning >Positioning methods.GPS receiverThe GPS receiver is located in the top of the device.When using the receiver, from an upright position,move the device to an angle of about 45 degrees,with an unobstructed view of the sky.Establishing aGPS connectionmay take from acouple ofseconds toseveral minutes.Establishing aGPS connectionin the car maytake longer.The GPS receiver draws its power from the devicebattery. Using the GPS receiver may drain thebattery faster.About satellite signalsIf your device cannot find the satellite signal,consider the following:● If you are indoors, go outdoors to receive a bettersignal.● If you are outdoors, move to a more open space.● Ensure thatyour hand doesnot cover theGPS antenna ofyour device.See "GPSreceiver", p. 58.● If the weatherconditions are bad, the signal strength may beaffected.● If the power saver turns on while the device isattempting to establish a GPS connection, theattempt is interrupted.● Establishing a GPS connection may take from acouple of seconds to several minutes.Satellite statusTo check how many satellites your device has found,and whether your device is receiving satellitesignals, press , and select Tools >58 Positioning (GPS)
