● Prompt password — If you must enter thepassword every time you log in to a server, or ifyou do not want to save your password in thedevice, select Yes.● Password — A password may be needed tomake a data connection and is usually providedby the service provider.● Authentication — Select Secure to always sendyour password encrypted or Normal to sendyour password encrypted when possible.● Homepage — Depending on the access pointyou are setting up, enter the web address or theaddress of the multimedia messaging centre.Select Options > Advanced settings to changethe following settings:● Network type — Select the internet protocoltype to transfer data to and from your device. Theother settings depend on the selected networktype.● Phone IP address (for IPV4 only) — Enter the IPaddress of your device.● DNS address — Enter the IP addresses of theprimary and secondary DNS servers, if requiredby your service provider. Contact your internetservice provider to obtain these addresses.● Proxy server address — Enter the address ofthe proxy server.● Proxy port number — Enter the port numberof the proxy server.WLAN internet access pointsPress , and select Tools > Settings >Connection > Access points > Options > Editor New access point.Follow the instructions from the WLAN serviceprovider.● WLAN network name — Select Entermanually or Search for networks. If you selectan existing network, WLAN network mode andWLAN security mode are determined by thesettings of its access point device.● Network status — Define whether the networkname is displayed.● WLAN network mode — Select Ad-hoc tocreate an ad hoc network and to allow devices tosend and receive data directly; a WLAN accesspoint device is not needed. In an ad hoc network,all devices must use the same WLAN networkname.● WLAN security mode — Select the encryptionused: WEP, 802.1x (not for ad hoc networks), orWPA/WPA2. If you select Open network, noencryption is used. The WEP, 802.1x, and WPAfunctions can be used only if the networksupports them.To enter the settings for the selected security mode,select WLAN security settings.Security settings for WEP152 Settings
