G e t s t a r t e d72. Connect the charger to the power source. For example, connect theDC-4 charger to the cigarette lighter socket of your car or the AC-5charger to a wall outlet. During charging, a battery animation scrollson the display and the red indicator light is displayed. Charging thebattery fully may take up to 2 hours and 10 minutes.If you use a charger that is connected to the cigarette lighter socket,power must be supplied by a 12-volt car battery. Ensure that thecharger is properly inserted in the cigarette lighter socket and doesnot interfere with the normal operation of the car.In some car models, the cigarette lighter socket is powered by the carbattery even when you remove the ignition key. In those cases, thecar battery might be discharged even if the speakerphone is not inuse. For more information, contact the vehicle manufacturer.3. When the battery is fully charged, the speakerphone beeps and isdisplayed. Disconnect the charger from the speakerphone, then fromthe power source.The fully charged battery has power for up to 30 hours of talk time or upto 180 hours of standby time.To check the battery charge when the speakerphone is not connected toa charger, see the battery indicator on the display. When the battery isfully charged, is displayed. When the battery charge is low, isdisplayed, the red indicator light flashes slowly, and the speakerphonebeeps about every 5 minutes. Recharge the battery.■ Switch on or offSwitch onTo switch on, press the power key. The speakerphone plays an ascendingsequence of beeps, the green indicator light flashes once, and thedisplay turns on. The speakerphone tries to connect to the device thatwas last connected to it ( is displayed).When the speakerphone is connected to your device and ready for use,the battery indicator and the Bluetooth name of the device is displayed.