NordicTrack Cx 1050 Elliptical User Manual

Also see for CX 1050: User manual

Contents

811. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath theelliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.8. Apply a liberal amount of grease to the long side ofeach M8 x 79mm Bolt Set (65).Identify the Left Pedal (10), which has a notch nearthe right side. Place the Left Pedal on the Left PedalLeg (4). Have a second person hold the bracket on theleft Upper Body Leg (31) inside of the bracket on theLeft Pedal Leg, and hold a Wheel (28) inside of thebracket on the left Upper Body Leg.Align the indicated holes, and attach the Left Pedal(10), the left Upper Body Leg (31), and the Wheel (28)to the Left Pedal Leg (4) with an M8 x 79mm Bolt Set(65). Attach the rear of the Left Pedal to the Left PedalLeg with two M8 x 54mm Button Screws (83) and twoM8 Split Washers (130)..Repeat this step on the right side of the elliptical exer-ciser.See step 4. Tighten the two M10 x 108mm ButtonScrews (70).41058313065 28Notch10.Plug the Power Cord (116) into the Power Socket(117) at the rear of the elliptical exerciser.116117109. Have another person hold the Console (17) near theUpright (2).Connect the Upper Wire Harness (115) to the wire har-ness on the Console (17). Connect the PulseExtension Wire (114) to the pulse wire on the Console.Next, locate the two ground wires that are attachedwith a screw to the Upright (2). Connect the groundwires to the two smallest wires on the Console.Carefully insert all excess wiring up into the Console(17) and down into the Upright (2). Attach the Consoleto the Upright with four M4 x 16mm Screws (98).(Note: The Screws may be shipped in the consolebox.) Be careful to avoid pinching the wires.17GroundWires298115114986531HolesGreaseDo not pinchthe wiresduring this step.