Nordson DuraBlue D4L Customer Product Manual

Also see for DuraBlue D10L: Manual

Contents

Nordson DuraBlue D4L Customer Product Manual Manual pdf 27 page image

Installation 3-1Part 1032059B 2003 Nordson Corporation Manual 41-DURABLUE-MA-02Section 3InstallationWARNING: Allow only qualified personnel to perform the following tasks.Follow the safety instructions in this document and all other relateddocumentation.Quick-StartIf you have already installed the melter using the installation guide(P/N 1024498) that is provided inside the shipping container, and you haveno questions concerning the installation, go to Setting Up the Melter later inthis section for information about how to prepare the melter to operate withyour manufacturing process.OverviewDuraBlue melters are factory-configured for each order and require only theassembly and set up tasks described in this section. If your melter wasordered as a complete system, the shipping container will also contain oneor more hot melt hoses and guns.The melter is shipped from the factory with an installation kit that containscomponents that must be assembled on the melter by the customer. Someadditional materials must also be supplied by the customer to complete theinstallation.If optional equipment was ordered with the melter, refer to thedocumentation provided with the optional equipment for installation andoperating instructions.The illustrations accompanying the procedures in this section depict theD10L melter. Unless otherwise noted, the instructions also apply to the D4Land D16L melters.Additional InformationThis section presents installation procedures in their most commonly usedform. Procedural variations or special considerations are explained in theadditional information table that follows most procedures. Where applicable,some table entries also contain cross-reference information. Additionalinformation tables are indicated by the symbol shown to the left.