Ready LEDOperation4-6Part 1032059B 2003 Nordson CorporationManual 41-DURABLUE-MA-02Monitoring the MelterThe melter provides indicators that allow you to: Quickly confirm that the melter is operating correctly Monitor the actual temperature of the tank group and each hoseand gun Identify melter faultsThe melter automatically determines the number and location of allhoses and guns that are connected to it. Refer to More AboutHeated Components, earlier in this section, for information about hose/guncapacity and the identification of heated components.Confirm that the Melter is Operating CorrectlyThe ready LED turns on (green) when all of the heated componentsare within 3 C (5 F) of their set-point temperature.The ready LED will not turn on, or will turn off, if any of the following eventsoccur: The ready delay is still counting down. The operator places the melter into the standby mode. The seven-day clock places the melter in the standby mode. There is a fault (the fault LED will turn on).Refer to Monitor Melter Faults and Using Melter Function Keys later in thissection for information about melter faults and using the seven-day clockand standby functions. Refer to Appendix B, Parameter 4, for informationabout the ready delay.
