90 Device Settings on the IP Phone 1120E with SIP FirmwareMenu items can also be accessed through the IP Phone 1140Ekeypad. Press the number (1-4) corresponding to a menu itemto highlight that menu item. Press the Select key to select thehighlighted menu item.To close this menu, use the Quit key.3 In the Network, choose 2. Device Settings.4 Enter the admin password. Press the OK Context-sensitive soft key.5 Use the Navigation key cluster to edit an item:Table 22Using the Navigation key cluster to navigate in the Device Settings menuKey ActionDown Opens list or moves highlight down list.Up Moves highlight up list.Right Selects the next item or moves the cursor right inan edit item.Left Selects the previous item or deletes a characterin the edit field.Select key (center of cluster) Selects the highlighted item in the combo box orends edit mode.In Edit mode, the first field of the item is highlighted. Press theApply&Reset Context-sensitive soft key to save settings in theDevice Settings menu after all the necessary changes are made.This action resets the IP Phone 1140E.Press the Return Context-sensitive soft key to exit the DeviceSettings menu without saving any changes.6 Navigate to the first item in the Device Settings menu to configureEAP.Table 23EAP configurationEnable 802.1x (EAP):Device ID:Password:A check mark appears in the check box if the item is active.7 If the Enable 802.1x (EAP) check box is checked, fill in the DeviceID and the Password.SIP Firmware Release 1.1 for IP Phone 1120E AdministrationNN43112-300 02.03 Standard27 May 2008Copyright © 2008, Nortel Networks.
