Connecting the components27Connecting the components of the phone1. Remove the stand cover. Press the Tilt Lever button and rotate thephone so that it hinges open to the maximum extent possible, asshown in Figure 3. Pull upward on the center catch. After the centercatch is released, lift up the top of the stand cover, and then pull ittoward the rear of the phone to remove it. The cable routing tracksare now accessible.Figure 5: Remove the stand cover2. Connect the AC power adapter (optional). Connect the adapter to theAC adapter jack in the bottom of the phone. Form a small bend in thecable, and then thread the adapter cord through the channels in thestand.Warning: Use your IP Phone 1140E with the approved Nortel ACAdapter (model #N0023000) for this model of phone only.Tilt LeverButtonCenterCatch
