Connecting the components306. Install additional cables. If applicable, plug in optional USB devices.Connect the Ethernet cable to the LAN Ethernet connection. If youare using an AC power adapter, plug the adapter into an AC outlet.7. Wall-mount your phone (optional). Your IP Phone 1140E can bemounted either by: (method A) using a traditional-style wall-mountbox with RJ-45 connector and 6-inch (15-cm) RJ-45 cord (notprovided), or (method B) using the mounting holes on the bottom ofthe phone stand.Figure 7: Rotate the phone into the wall mount position.• Rotate the phone into the wall-mount position by holding the TiltLever and rotating to get past the soft stop. After you pass the softstop, release the Tilt Lever and continue to rotate the phone, asillustrated in Figure 7. To lock it into the wall-mount position, lift thewall-mount lever (located just under the Handsfree key), as shown inFigure 7, and complete the rotation of the phone into the lockedposition• Use either method A or method B to wall-mount your phone.Wall-mount leverTilt lever
