Nortel 2050 Installation Manual

Also see for Softphone 2050: User guide Installation and operation Installation and operation guide Fundamentals Fundamentals

Contents

Nortel 2050 Installation Manual Manual pdf 27 page image

NORTEL TPS 3D SENSOR AND DEFENSE CENTER INSTALLATION G UIDE RELEASE 4.7.0 PAGE 27Chapter 2: InstallationTPS 2070 DC5. To determine the name of the management interface, enter the followingcommand: grep MANAGEMENT /etc/sf/ims.conf6. To configure the management interface, enter the following command:ifconfig eth# ipaddr netmask mask broadcast bcastaddrwhere eth# is the result you received for the command in the previous step, andipaddr, mask, and bcastaddr are the values you want to use in your networkenvironment.For example:ifconfig eth0 192.168.10.5 netmask 255.255.255.0broadcast 192.168.10.2557. If the Defense Center is on a different subnet from the web browser, add adefault route as shown in the following command:route add default gw gw_addrwhere gw_addr is the IP address of the default gateway.For example:route add default gw 192.168.10.18. Continue with “Performing the initial setup” on page 27.Performing the initial setupAfter you physically install the Defense Center and set up the IP address for themanagement interface, you must log into the Defense Center's web interface andcontinue the setup process. After you perform the initial setup, refer to your userguide for information about the next steps you need to take.See the following sections for more information:• “Accessing the web interface” on page 27• “Changing the default password” on page 28• “Configuring the network settings” on page 28• “Setting up the base license” on page 30• “Setting up remote management” on page 30• “Installing software updates” on page 31• “Importing SEUs and rule files” on page 31• “Configuring a system policy” on page 32Accessing the web interface1. Connect to the management interface securely to access the GUI.To access the GUI through the management interface, browse to the IPaddress you configured in the previous procedure, for example,https://192.168.10.5.The Login page appears.