Chapter 6 Remote Node setup 89Nortel Business Secure Router 252 Configuration — AdvancedEncapsulation PPPoA refers to RFC-2364 (PPP Encapsulation over ATMAdaptation Layer 5).If RFC-1483 (Multiprotocol Encapsulation over ATMAdaptation Layer 5) of ENET ENCAP are selected, then theRem Login, Rem Password, My Login, My Passwordand Authen fields are not applicable (N/A).ENETENCAPMultiplexing Press [SPACE BAR] and then [ENTER] to select themethod of multiplexing that your ISP uses, either VC-basedor LLC-based.LLC-basedService Name When using PPPoE encapsulation, type the name of yourPPPoE service here.N/AIncoming:Rem Login Type the login name that this remote node will use to callyour Business Secure Router. The login name and the RemPassword will be used to authenticate this node.RemPasswordType the password used when this remote node calls yourBusiness Secure Router.Outgoing:My Login Type the login name assigned by your ISP when theBusiness Secure Router calls this remote node.My Password Type the password assigned by your ISP when theBusiness Secure Router calls this remote node.Authen This field sets the authentication protocol used for outgoingcalls. Options for this field are:CHAP/PAP – Your Business Secure Router will accepteither CHAP or PAP when requested by this remote node.CHAP – accept CHAP (Challenge HandshakeAuthentication Protocol) only.PAP – accept PAP (Password Authentication Protocol)only.Route This field determines the protocol used in routing. Optionsare IP and None.IPBridge When bridging is enabled, your Business Secure Router willforward any packet that it does not route to this remotenode; otherwise, the packets are discarded. Select Yes toenable and No to disable.NoEdit IP/Bridge Press [SPACE BAR] to select Yes and press [ENTER] todisplay Menu 11.3 – Remote Node Network LayerOptions.NoTable 18 Menu 11.1 Remote Node Profile (continued)Field Description Example
