Telephone settings179Configuring Cadence ModeA cadence defines the duration of the on and off phases of a ringingcycle. You can use the Tones and Cadences feature on theCommunication Server 1000 (CS 1000) system to configure ringcadences to identify different types of incoming calls. For moreinformation about Tones and Cadences on CS 1000, see Features andServices Fundamentals (NN43001-106).To cause your DECT handset to use the ring cadences configured onyour CS 1000 system, you must activate Cadence Mode on your DECThandset. This allows the PBX system to control the on and off phases ofthe ringing cycles on the handset. If Cadence Mode is disabled on yourhandset, the handset continuously plays its ringing melody on anyincoming call, irrespective of the Tones and Cadences configuration onyour CS 1000 system.To activate Cadence Mode on your handset, perform the following steps:4. Press the Up or Down key to select On or Off.5. Press the Select soft key to apply the changes.6. Press the Clr key one or more times to return to theidle display.Attention: Cadence Mode is applicable to traditional DECT systemsonly (based on DMC cards). If you enable or disableCadence Mode for a SIP DECT solution, there is no impact.1. Open the Sounds and alerts menu using the stepsin “Accessing the Sounds and alerts menu”(page 167).OnOffSelect
