Nortel 4500 Series Installation Manual

Also see for 4500 Series: Cli manual Overview-System Configuration Installation

Contents

Nortel 4500 Series Installation Manual Manual pdf 40 page image

40 Installing the Nortel Ethernet Routing SwitchThe Read-Only Community String prompt line appearsPlease provide the Read-Only CommunityString[**********]:******The confirm Read-Only Community String prompt line appearsPlease confirm the Read-Only CommunityString[**********]:******The Read-Write Community String prompt line appearsPlease provide the Read-Write CommunityString[**********]:*******The confirm Read-Write Community String prompt line appearsPlease confirm the Read-Write CommunityString[**********]:*******The Quick Start VLAN prompt line appearsPlease provide the Quick Start VLAN <1-4094> [1]:The Basic Switch parameters configuration confirmation appearsBasic switch parameters have now been configured andsaved.—End—Note: Nortel Ethernet Routing Switch 4500 Series console portsupports Nortel CLI only. When the switch is set to factory defaultparameters, the CLI Quickstart displays.Setting IP parameters using the console port and CLIIf the switch is configured beyond factory default settings, perform thefollowing procedure to set IP parameters using the console port andCommand Line Interface (CLI):Step Action1 Connect a terminal to the console port of the switch. Any terminalor PC with an appropriate terminal emulator can be used as themanagement station. See "Setting IP parameters using the consoleport and CLI Quickstart" (page 38).2 Set the terminal protocol on the terminal or terminal emulationprogram to VT100 or VT100/ANSI.Nortel Ethernet Routing Switch 4500 SeriesInstallation GuideNN47205-300 02.01 Standard5.0 23 February 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.