Setting IP parameters for the Nortel Ethernet Routing Switch 4500 Series 413 Connect to the switch using the terminal or terminal emulationapplication.4 After the Nortel banner appears, press CTRL + Y to display themain menu. Depending on whether the switch is stand-alone or in astack configuration the stand-alone switch main menu or the stackswitch main menu displays.5 From the main menu, select Command Line Interface...6 To enter the Global Configuration command mode, use the enablecommand.7 At the prompt, enter the configure terminal command.8 At the prompt, enter the ip address command to set the switchor stack IP address.Following is the ip address command syntax:ip address [stack | switch} [netmak] [default-gateway address>]The following table describes the ip address commandparameters.Table 1ip address parametersParameter Description[stack | switch] Use either the stack or switch key word to set theappropriate IP address. The IP address to be used. The subnet mask to be used. The default gateway address to be used.—End—The IP configuration is now complete.To continue configuration, use the appropriate CLI commands.To disconnect from the switch, do the following:Step Action1 To return to the Console Menu, use the logout command.2 Select Logout from the main menu.Nortel Ethernet Routing Switch 4500 SeriesInstallation GuideNN47205-300 02.01 Standard5.0 23 February 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.
