146 Chapter 14 Using Element Manager to set the basic parametersNN40020-302To configure the SNMP manager listUse the SNMP manager list to specify IP addresses that can connect to the SNMP agent.1 From the Configuration tab, click the Administrator Access folder to expand it.2 From the Administrator Access folder, select SNMP.3 Select the General tab. It is normally selected by default.4 In the SNMP Manager List area, click Add.The Add Manager dialog box appears.5 Enter the IP address in the Manager IP Address field.6 Click OK.7 Repeat steps 4 to 6 to add another manager IP address.To create user accounts1 From the Configuration tab, click the Administrator Access folder to expand it.2 From the Administrator Access folder, select Accounts and Privileges.3 Select the View by Accounts tab.4 Click Add to add a user account.The Add Account dialog box appears.5 Configure the Add Account attributes. See the table Add Account attributes on page 146.Table 30 Add Account attributesAttribute DescriptionDescription Enter a description for this account.User ID Enter a descriptive name for the user or the user function.Password Enter a password for this account.Telset user ID (numeric) If the user performs administration through the Telset interface, enter anumber for the user ID.Telset password (numeric) Enter a password for the Telset User ID.Modem Callback Number If Callback is required, enter the number to which the system calls back toverify the dial-up user access.Modem Callback Passcode This is the code the system uses to confirm the callback is legitimate.ISDN Callback Number If ISDN Callback is required, enter the number to which the system calls backto verify the dial-up user access.ISDN Callback Passcode This is the code the system uses to confirm that the ISDN callback islegitimate.Change Password On Login Select this check box to force the user to change the password upon firstlogin.Change Password On LoginTelsetSelect this check box to force the user to change the Telset password uponfirst login.