Nortel BayStack 100-S Reference

Also see for 400: Install guide Release note Using Setup Quick reference guide

Contents

Nortel BayStack 100-S Reference Manual pdf 40 page image

40 Chapter 2 Using configuration commands302005-Fifconfig commandThe ifconfig command displays or sets parameters for the interfaceconfiguration.Table 10 describes the ifconfig command options.Table 10 ifconfig command optionsOption Definitioninterface The physical interface name.disable Disables the specified interface.hhmm - The time, using hours and minutes, to disable the interface.clear - Clears the disable command.When is provided, the unit automatically disables theinterface at the specified time. The value is entered as four digitsbased on a 24-hour clock.enable Enables the specified interface.hhmm - The time, using hours and minutes, to enable the interface.clear - Clears the disable command.When is provided, the unit automatically enables the interfaceat the specified time.infilter Sets or clears the input filter applied to incoming traffic.filterlist - An arbitrary name of the filter list.clear - Clears the infilter command.hwaddress Sets the Ethernet address for the interface. Allows you to transfer thedesignation of a single MAC address from a particular PC to theInstant Internet unit for LAN support. NOTE: You should seriouslyconsider the repercussions before making changes to this parameter.adr - The 6 byte MAC address that you want to set the InstantInternet to.ifconfig [ [disable [ | clear]enable [ | clear]infilter | clearhwaddress ipaddress []mtu outfilter | cleartransparent on | offupdate xlate on | in | out | off]]