Preparing for the CVX 600 Installation1-16 296-1011-202 Rel. 5.0, Doc. Rev. 02.01CVX 600 Hardware Installation GuideTools and Equipment NeededBefore you install the CVX 600 chassis, ensure that you have all of the necessarytools, cables, console equipment, and mounting hardware.ToolsYou must have the following tools:• Screwdrivers:— Phillips #2 screwdriver— 1/16-inch and 1/4-inch flat-tip screwdrivers• Nut drivers (nonmetric sizes) for securing power and ground cabling• Volt/ohm meter for power connectionsCables and Cable TiesThe shipment does not include the cables required for the telephone side of yournetwork. Ensure that the installation site has the proper network cabling.Cable ties are needed to bundle network and power cables, to provide access toLTM and RLTM modules.Service ConsoleYou can connect a local terminal or a PC to the CVX 600 to monitor startupdiagnostics and to perform manual startup and configuration. See Chapter 2,“Chassis Connections,” for information on installing a service console. See thefollowing software manuals for information on configuring the CVX 600 accessswitch:• CVX Multi-Service Access Switch Startup Guide• CVX Multi-Service Access Switch Configuration Guide
