Connecting Equipment to the Console Port296-1011-202 Rel. 5.0, Doc. Rev. 02.01 2-37Chassis ConnectionsConnecting a ModemIf you need remote dial-in access to the command line interface (CLI), you canconnect a modem (AT or Hayes compatible) to the CVX 600 using the DB-9 toDB-25 modem cable.To connect a modem to the CVX 600, follow these steps:Step Action1 Turn on the modem, then configure it using the parameters listedbelow.For instructions, see the documentation for the modem.Modem Parameter Value/StateBaud rate 56 Kb/s (or less)Auto answer Set to n rings with DTR active.(The value n must be greater than0. If the value is 0, Auto answer isdisabled.)Clear to send (CTS) signal Always onData terminal ready (DTR) signal DTR signal fail-disconnectenabled. Return to commandmode; Auto answer is disabled.Data carrier detect (DCD) signal DCD signal on while carrierpresent. (The CVX 1800 uses theDCD signal to detect a modemdisconnect.)Local character echo OffSupervisory functions OffData set ready (DSR) signal On2 Turn off the modem.3 Remove the console cable from the console port.(continued)
