Nortel CallPilot 100 Set Up And Operation Manual

Also see for CallPilot 100: Installation and Maintenance Administration guide Quick start guide Administration guide Installation and maintenance guide

Contents

Nortel CallPilot 100 Set Up And Operation Manual Manual pdf 23 page image

23CallPilot Message Networking Set Up and Operation GuideChapter 3Setting up AMISSetting up AMISAMIS provides your site with network voice messaging features. This chapter describes how to setup and test AMIS on your Business Communications Manager or CallPilot 100/150 system.AMIS networking propertiesAMIS networking properties are:Note: Make sure that your Company Greetings are 15 seconds or longer. For how torecord Company Greetings refer to the CallPilot Manager Set Up and Operation Guide.AMIS Networking properties are not available if you have a CallPilot 100 that isconnected to a Compact 3X8 ICS.International Access code This code identifies the country where your site is. This code allowsinternational calling capability. In Canada and the United States, theInternational Access code is 011. This number can have a maximum of fourdigits.Country code This code is assigned to the country where your site is located. In Canadaand the United States, the Country code is 1. This code can have amaximum of four digits. This information is used to generate the returnaddress of your location.Area code This code is assigned to your calling area. For example, the area code forKansas City is 816 and the area code for Calgary is 403. Each province,state, and, sometimes city has a specific area code. This number can havea maximum of six digits. This information is used to generate the returnaddress of your location.Telephone number The system telephone number at your site is the number assigned to theAuto Attendant. This number can have a maximum of 16 digits. Thisinformation is used to generate the return address of your location.Outdial route The numbers your site uses to access Line, Pool or Route codes. TheOutdial route is the Line or Pool number that AMIS uses to make anoutgoing call or the Route code used to call a specific site.Enable Loopback mailbox You use a Loopback Mailbox to test if two sites are communicating. Whena Loopback mailbox receives a message, it sends it back to the originatingmailbox. Before you can test network message capability, you must enablethe Loopback Mailbox.The Loopback mailbox is not enabled by default. Enable the Loopbackmailbox while you set up and test your network. Disable the Loopbackmailbox after you know that it is working.