Technical Product Manual - DCT1900Installation Instructions, Base Station – KRC 101 1371Install-DCT1900/R8/mw 16-7© 2000-2005Fig. 16–2 Connector PinningNote:After completion of the installation, Base Stations must be added using the CSMW “Installer QuickGuide”.16.6 Base Station Mounting - Indoor16.6.1 Wall MountThe Base Station comes with its own Base Station mounting bracket. The necessary antenna areordered and shipped separately. The Base Station is to be mounted such that when wall mountedthe top of the antenna is at least 6 inches below the ceiling. If the ceiling is made of metal orcontains a metal plate, the distance between the metal plate and the antenna must be at least onefoot.Once the location where the Base Station is to be mounted has been determined, take themounting plate (see Fig. 16-1, Base Station Cover and Back) and spot it where the Base Station isto be mounted.1. Mark the location for the mounting hardware.2. Secure the rear bracket to the wall. Use #6 mounting hardware. The side of the bracket withthe part no. SXANB 101 127/X goes towards the wall.3. Plug the Base Station cable into either one of the RJ45 jacks on the back of the Base Station.4. Place the Base Station over the rear plate on the wall and slide it down until the Base Stationlocks in place onto the rear bracket.5. Connect the antenna to the Base Station, then slide the rubber grommet supplied with theantenna kit down over the antennas until they are firmly seated in the Base Station itself.16.6.2 Ceiling MountA kit, part number NTM 201 1754 is provided for the ceiling mounting of base stations. Ine kit isrequired for each ceiling mounted base station. Teh following instructions, also the kit are includedfor reference.Instructions - Ceiling Mount Kit1. Cut out center portion of mounting clip to make room for ceiling clip threads.RJ45modular jackEPP1EPP0SC1-0SC0-0SC0-1SC1-1NCNCSC=Serial ChannelEPP=Express Power PairNC=Not ConnectedPin 3 = SC1-0 - white/bluePin 4 = SC0-0 - white/orangePin 5 = SC0-1 - orange/whitePin 6 = SC1-1 - blue/whitePin 1 = EPP1 - green/whitePin 2 = EPP0 - white/green
