Nortel Meridian Meridian 1 Implementation Manual

Also see for 1000 Con?guration guide: Brochure Reference User manual Overview User guide

Contents

Page 66 of 208553-3001-358 Standard 1.00 October 2003This procedure is now complete6 Insert the other end of the RJ11 plug into the RJ11 jack on the wall.Procedure 10Access the MICB remotely using a LAN hub – Succession 1000,Succession 1000M Cabinet, and Meridian 1 Option 11C Cabinet1 Verify that the Ethernet Adapter/MAU is installed. Insert the industry-standardMAU into the Ethernet Connection on the back of the Succession Call Serverand Succession Media Gateway.Note: The MAU comes with the cable kits for the Succession Call Server andSuccession Media Gateway.2 Insert the modular cable RJ-45 plug into the RJ-45 jack on the EthernetAdapter/MAU.3 Insert the RJ-45 plug at the other end of the modular cable into the LAN hub.4 Make the rest of the Ethernet connections as required using standardThis procedure is now completeEthernet connection rules.Procedure 11Install MICB cards1 Identify the card slots selected for MICB card(s). Refer to Table 5 on page 42.2 Make sure to properly place the PCMCIA hard drive card in the lowerfaceplate PCMCIA slot.3 Pull the top and bottom extractors away from the MICB faceplate.4 Insert the MICB card into the card guides and carefully push it until it makescontact with the backplane connector.5 Push the top and the bottom extractors towards the faceplate to insert theMICB card into the faceplate connector and to lock it in place.6 Observe the red LED at the top of the faceplate (the card LED).This LED blinks three times after the self-test successfully completes. Whenthe MICB software loads, the LED blinks three more times and then remainslit. This takes approximately 45 seconds.This procedure is now complete7 Repeat Steps 1 through 6 for each additional MICB card.Procedure 12Set up CLI access from the Maintenance1 Specify the VT-100 type terminal interface characteristics to make sure theyare compatible with the MICB RS-232 interface.2 Set the interface parameters as follows:• Transmission speed: 9600 bps• Data bits: 8• Stop bit: 1