64 Chapter 3 Installing the 8010co chassis316314-E Rev 01Mounting the 8010co chassis in a Hendry rackTo install the 8010co chassis in a Hendry rack:1 Place the installation shelf at the bottom of the rack.2 Holding the installation shelf in position, align the shelf’s mounting rail withtwo holes on each side of the vertical rack support.3 Insert a hex head screw through each installation shelf mounting hole and intothe corresponding hole in the rack (Figure 32).Figure 32 Installing the installation shelf in a Hendry rack4 Tighten each screw with a nutdriver.5 Using a Phillips screwdriver, remove the 5 screws securing each of the twomounting rails to the 8010co chassis (Figure 33 on page 65).10402FB2311 = Hex head screws (x4)2 = Installation shelf3 = Hendry equipment rack
