|
Chapter 6 Setting up the private VoIP network 77Survivable Remote Gateway 50 Configuration GuideBasic parametersThe following table provides a record of basic parameters that are significant for SRG operation.Typically, these parameters are specified as part of BCM50 foundation activities; in most cases,their configuration is not covered in the Survivable Remote Gateway 50 Configuration Guide.Table 11 Basic parameters (Sheet 1 of 2)Parameter Value ContextDN length Configured as part of BCM50 foundation configuration.There are four DN lengths to consider.1. Configuration > Telephony > Dialing Plan > General >Dialing Plan - General panel > Global Settingssubpanel > DN length (intercom) fieldThis is the internal DN length. That is, the length of DNs for callsbetween telephones on the SRG50.2. Configuration > Telephony > Dialing Plan > Public Network >Dialing Plan - Public Network panel> Public Network Settingssubpanel > Public Received number length fieldFor calls originating from the PSTN, this establishes the number ofdigits the SRG50 retains.3. Configuration > Telephony > Dialing Plan > PrivateNetwork > Dialing Plan - Private Network panel > PrivateNetwork Settings subpanel > Private Received number lengthfieldFor calls originating from a private network, this establishes thenumber of digits the SRG50 retains.4. Configuration > Telephony > Dialing Plan > PrivateNetwork > Dialing Plan - Private Network panel > PrivateNetwork Settings subpanel > Private DN length fieldUsed for DPNSS applications only. Refer to the BCM50 NetworkingConfiguration Guide (N0027156).DN range Configured as part of BCM50 foundation configuration.DN range of the SRG50 is set by the hardware configuration andkeycodes. Actual numbering is contiguous from the Start DN:Administration > Utilities > Reset > Reset panel > Cold ResetTelephony Services button > Cold Reset Telephony pop-upwindow > Start DN fieldDestination codefor VoIP trunksConfigured for advanced routing. Refer to “Call routing: configuringfor outgoing calls” on page 86VoIP destination code = VOIP Trunk Access Code* = AC1*** VOIP Trunk Access Code is entered on the main office settingspanel. Refer to the server-specific chapters for details.** For a UDP dialing plan, AC1 is the access code in the digit string .SRG50 IPaddressConfigured as part of BCM50 foundation configuration.Path: Configuration > System > IP Subsystem > IP Subsystempanel > General Settings tab > IP Settings details subpanel
|
