Nortel T7406 Installation Manual

Contents

Installing the Base Station / 23T7406 Installation GuideBefore you start• Ensure there is an AC power outlet within 1.5 meters (5 feet) of thebase station location.• Ensure that the telephone lines from your system have been installedto the base station location.Mounting and Connecting the Base StationFollow these steps to mount and connect each base station.1. Use the mounting bracket as a template to position the basestation and mark the screw positions.2. Use screws to attach the mounting bracket to a wall or ceiling.3. Set the base station dip switches, located on the back of the basestation, to the required ISM frequency band.4. Connect the telephone lines to the base station.• On the first base station you install,set the dip switches to operate in theupper half of the ISM band. From leftto right, set to Down-Up-Down.• On the second base station, set the dipswitches to operate in the lower halfof the ISM band. From left to right,set to Down-Down-Up.a. Plug one end of the line cord into atelephone jack on the base station.b. Connect the other end into a telephoneport on the system equipment.Note:Connect a maximum of threeTCMs per base station to the system.c. Plug the small end of the poweradapter into the back of the basestation.d. Plug the other end into an AC outlet.Note:A red light flashes continuouslyon the base station when powered.Upper halfISM Band1 2 3Lower halfISM Band