80 Installation• Flashing red - indicates that the ATA is operating normally. For moretroubleshooting guidelines, refer to the user documentation that camewith your analog device.• Solid red - indicates that the ATA is not operating normally.• Red light off - indicates that there is no power going to the ATA or theunit is not operating correctly. Check the power connections to theATA.Flexible voice and data capabilities allow you to have continuous use ofboth the Meridian Digital Telephone and the attached analog device. Yoursystem administrator configures the flexible voice and data capabilitiesfor your telephone on the system equipment. Contact your systemadministrator for more information about flexible voice and data capability.When there is a power failure to the ATA, the Analog Device does notstore or keep information (for example, outgoing FAX from your FAXmachine). You must send the information again when power returns.Table 18 "ATA configuration" (page 80) shows prompts and responseswhen configuring the ATA.Table 18ATA configurationPrompt Response DescriptionSO NEW Establish service forunassigned telephonelines.LCC ATA Analog terminal adapter lineclass code.Ringtype, group, subgroup,NCOS, SNPA, key, ringingFollow normal administrationprocedures for an M3901 telephonefor these prompts.The prompts require datafillspecified by the customersite.LEN_OR_LTID A B C D A = IPE column.B = IPE shelf.C = IPE card slot.D = IPE odd port.OPTKEY $ There are no optionsavailable for the ATA.Meridian External Alerter and Recording Interface (MEARI)Install the MEARI in the small dock of a M3902, M3903, M3904, orM3905 set. There are three output connectors on the back of the MEARIcartridge. There is no need to disconnect the power supply from thetelephone prior to insertion or extraction of the MEARI cartridge.Nortel Communication Server 2100M3900 Series Meridian Digital Telephones User GuideNN42200-110 09.01 Standard20 August 2008Copyright © 2008 Nortel Networks.
