Notifier AFC-600 Programming Manual
Also see for AFC-600: Operating manualInstallation manual
                                                                                                                | |
Contents
| 
3URJUDP &KDQJH How to Use the Basic Program16 AFC-600 Programming PN 51032:A 3/8/99+RZWR$XWRSURJUDPWKH&RQWURO3DQHO $8723XUSRVH The Autoprogram option identifies all addressable devices connected to the controlpanel. Devices include addressable detectors and modules connected to SLC 1 andSLC 2, Panel Circuits connected to J1 and J2, and NACs. You can use the Autoprogramoption to create a new program and add or remove devices. Table 6 contains a summaryof the Autoprogram functions, when to use the functions, and where to find informationon using the functions.7DEOH $XWRSURJUDP )XQFWLRQV&UHDWH D 1HZ 3URJUDPIRU WKH &RQWURO 3DQHOThis section covers how to use the Autoprogram option to create a new program for thecontrol panel. The control panel will identify all addressable detectors and modulesconnected to the SLC then display default program information for each installeddevice.To create a new program for the control panel, follow these steps:1. Use the Clear option to clear program information from memory. For instructionson clearing memory, refer to "How to Clear Memory (0=CLR )" on page 15.2. From the Program Change screen, press the 1 key to start Autoprogram. Thecontrol panel scans the system to identify all SLC devices and Panel Circuits anddisplays the following screen:)LJXUH $XWRSURJUDP 3URPSWContinued on the next page...Autoprogram Function Control Panel Configuration Refer to...Create a new programfor the control panelA new control panel or acontrol panel with no existingprogram in memory."Create a New Program for theControl Panel" on page 16Add one or moreSLC-connecteddetectors and modulesto an existing programA program exists in memoryand you want to add a detectoror module to the existingprogram—without modifyinginformation for existingdetectors and modules."How to Add a Device to theProgram" on page 18Remove one or moreSLC-connecteddetectors and modulesfrom an existingprogramA program exists in memoryand you want to remove aninstalled detector or modulefrom the existing program—without modifying informationfor existing detectors andmodules."How to Remove a Device fromthe Program" on page 19View system defaults A program exists in memoryand you want to view systemsettings assigned duringAutoprogram, such as customlabels, passwords, and so on."How to Change AutoprogramDefaults for System Functions"on page 20$872352*5$0 3/($6( :$,7Technical Manuals Online! - http://www.tech-man.com |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine