Notifier AFP-3030 Installation Manual

Also see for AFP-3030: Programming manual Operation manual Operation manual Installation manual

Contents

Notifier AFP-3030 Installation Manual Manual pdf 25 page image

AFP-3030 Installation Manual — P/N DOC-01-037:B 25/08/2016 20Installing a Replacement Zone Mimic (ACM-ZM) Installation4. If the ACM-ZM is the last device on the line, set the Comms EOL Terminator jumper to theON position; otherwise, leave the Comms EOL Terminator jumper in the OFF position.5. Secure the ACM-ZM to the spacers on the NPS mounting bracket using two (2) M3 screws, asshown in Figure 3.13. Ensure that the ACM-ZM is mounted with the Comms/Power header attop right.3.8.1 Installing a Zone Mimic Expansion Card (AEM-ZM)The Zone Mimic Expansion card increases the number of feedback LEDs on the ACM-ZM. Theadditional LEDs can be programmed to represent the active state of any zones or outputs connectedto the panel.1. Screw the AEM-ZM to the vacant threaded spacers beneath the ACM-ZM card on the NPSMounting Bracket, as shown in Figure 3.14.2. Connect the replacement ACM-ZM to the fire panel as per the relevant drawing inAppendix C, “Schematics”, on page 46.Figure 3.12 ACM-ZM termination jumper settingsFigure 3.13 Mounting the ACM-ZM